Welcome Centurium inscription hardware (machinery) factory Official network!

National service hotline

15999872868

News Center

  • Tel:086-0769-85827371
  • Mobile:15999872868
  • E-mail:zhengming22337@sina.com
  • Address: Building 6,Chi Ling District Yi Hong Rong Science and Technology Park,Houjie Town,Dongguan,Guangdong Province,China.

Common problems and treatment methods of shoe material compound machine.
From: Centurium inscription hardware (machinery) factory Post date: 2018-04-28


One, the whole machine cannot work.
1. Causes:
A. the power switch is not opened.
B. The fuse blew out.
C. "stop" press button to not return.
D. time relay, intermediate relays are loose and burnt.
E. 2# and # 3 terminal are off.
2. Treatment methods:
A. Check whether there is electricity to be delivered and turn on the power switch.
B. Check whether the fuse has been burned or not, if so, please replace it.
C. Each "stop" press the button several times to enable it to return.
D. Tightening time relay, intermediate relay or replacement.
E. Check the #3# terminal and eliminate the disconnection.
2. Electric heating, no heating or slow heating.
1. Causes:
A. The heating switch is not opened or the temperature control meter is set below the induction temperature.
B. The thermostat "SB" is flashing red.
C. The heating contactor does not absorb.
D. The heat pipe is damaged.
2. Treatment methods:
A. Turn on the heating switch and set the temperature control meter.
B. Replace the thermal or temperature control table.
C. Replace the heating switch or contactor.
D. Inspect or develop heat pipe installation holes with multimeter, and check the heating pipes without exception in the heating condition. If there is any, please replace them.
Steam heating, not heating or heating slowly.
1. Causes:
A. the steam valve is not opened.
B. The heating switch is not opened or the temperature control meter is set below the induction temperature.
C. the thermostat "SB" is flashing red.
D. the steam pipe is blocked and damaged.
E. heating contactor does not suck.
2. Treatment methods:
A. Open the steam valve.
B. Turn on the heating switch and set the temperature control meter.
C. Replace the thermal or temperature control table.
D. Inspect and process the steam pipe to ensure that the pipe is unblocked.
E. replace the heating switch or contactor.
F. Large drum drainage.
4. Uneven adhesion.
1. Causes:
A. The rubber wheel and the knife board are not good.
B. Improper adjustment of rubber pressure wheel.
C. The rubber wheel bearing is broken, and the inner and outer ring.
D. The rubber wheel scratches rust.
2. Treatment methods:
A. grind the knife with grinding sand.
B. Adjust the gluing wheel.
C. replace the bearing, or the rubber wheel.
D. Put on the rubber wheel and change the glue (the glue is too acidic).
Fifth, the network belt running deviation.
1. Causes:
A. The side cylinder is in the wrong direction.
B. electrical eye failure
C. Uneven adjustment of mesh belt.
D. The "manual/automatic" switch on the electrical cabinet panel is in the manual position.
2. Treatment methods:
A. Change the direction of the cylinder.
B. Clean the light of the electric eye.
C. Adjust the tightness of the mesh belt.
D. The "manual/automatic" switch on the electrical cabinet panel selects the automatic position.
Dongguan xingdai machinery technology co., LTD. Main: slitting machine.

  • Copyright:Centurium inscription hardware (machinery) factory
  • Record number: Technical support:Acshoes() Cantonese public net:
Applet

Applet

mobile

mobile

H
O
T

Online consulting:

086-0769-85827371